Jungheinrich Etv 216 Error Codes -

: Seat belt or belt lock is not closed while the pedal is pressed.

| Code | Description | Possible Cause / Solution | | :--- | :--- | :--- | | | Drive Controller Fault | General electronics fault. Requires connecting a Jungheinrich diagnostic tool (ProDiag) to read the sub-code. | | E 102 | Throttle Sensor Fault | The accelerator pedal (hall sensor) signal is out of range. Check the pedal connection or replace the sensor. | | E 104 | Seat Switch / Seatbelt | The truck will not drive. Check if the seat switch is engaged or if the seatbelt is connected (if equipped with interlock). | | E 110 | Phase Fault / Motor Connection | Check the cable connections between the drive motor and the controller (U, V, W phases). | | E 112 | Speed Sensor Fault | Fault in the impulse encoder/speed sensor on the drive motor. | | E 115 | Battery Voltage Too Low | Voltage dropped below the cut-off limit. Charge the battery. | | E 116 | Battery Voltage Too High | Occurs often if the truck is plugged in while the key is on, or if the battery is overcharged. | jungheinrich etv 216 error codes